Mar 14, 9: And i backed up the old modules. Trademarks Privacy Policy Terms of Use. Sign up using Email and Password. Originally, the driver that shipped with the Linux kernel would not allow me to bring the link up. Mar 9, 2:

Uploader: Mezizilkree
Date Added: 2 November 2011
File Size: 57.94 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 25774
Price: Free* [*Free Regsitration Required]

ENC28J60 – Ethernet Controllers – Interface and Networking

We are glad that we were able to resolve this issue, and will now proceed to close this thread. It’s possible, the driver exists in the kernel source code, and Chris Boot already did-it before.

I get the following after bringing the interface up. I am running on version 4.

In reply to Chiahsing Wu:. Ask a related question What is a related question? There could be any conflicts in dhcpcd. In reply to Chiahsing Wu: I correctly find new eth1 interface running ifconfig missing interface if enc28j60 module unconnected.


Then it should just work like any other ethernet controller. Mar 9, The use of baseball bats for educational purposes is completely disallowed on this forum.

In reply to Pavel Botev: Last edited by Killertechno on Fri Nov 23, 8: Right now, I am trying to figure it out why P8 don’t need to have pinmux value. I’m wondering my interrupt pins might not configure correctly.

Testing write buffer coherency: After a bunch of debugging, I found that if I waited some amount of time during board initialization, that I could get the link to come up.

You have BeagleBoneBlack base board and you connect your enc28j60 chip to the P8 connector, and it is working fine, is this correct? As I understand the steps are: And i backed up the old modules.

CONFIG_ENC28J60: ENC28J60 support

And when you connect your enc28j60 chip to P9 connector, it stop working, is this correct? The newly created question will be automatically linked to this question.

Post as a guest Name. Chiahsing, Let me clarify your use case.


I tried to recompile the module with this: Is this what you enc2j860 referring to? No license, either express or implied, by estoppel or otherwise, is granted by TI. Thankfully i skiped the last step. Ask a related question Ask a new question.

I would like to know why I can not use P9. If you have a related question, please click the ” Ask linkx related question ” button in the top right corner. Hi Chiahsing, Have you check the below e2e thread? Go to Embedded Software Read Only.

Does anyone with knowledge of Linux network drivers or Microchip’s ENC28J60 know what I should be looking into to resolve this problem?